Mountaineer AWD V8-4.6L SOHC VIN W (2002)
water.
NOTE: Use clean, fresh Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification
ESA-M6C25A.
^
Do not reuse brake fluid drained or bled from the system.
^
Do not use brake fluid that has been stored in an open container.
^
Do not use contaminated brake fluid.
1. Remove the disc brake caliper.
2. Drain remaining brake fluid from the disc brake caliper.
3. Secure the disc brake caliper in a vise.
4. Remove the caliper pistons.
1. Place a block of wood between the caliper bridge and the caliper pistons.
2. Apply low air pressure to the fluid port in the disc brake caliper.
3. Force out the caliper piston to the block of wood.
4. Remove the block of wood and the caliper pistons.
5. Remove and discard the piston seals and boots.
6. NOTE: Do not hone the caliper bores. Pistons are not available for honed caliper bores.
If the caliper bores are excessively scored or corroded, install a new disc brake caliper.
Assembly
1. CAUTION: Never reuse piston seals or dust boots.
