Mountaineer AWD V8-4.6L SOHC VIN W (2002)
9. Set the halfshaft assembled length to specification.
1
Measure the entire assembly length.
2
Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length to specification.
3
Hold the inner joint to prevent the assembled length from changing, and insert a small flat blade screwdriver between the boot and the joint to
equalize the pressure.
10. NOTE: Tighten the through-bolt until the special tool is in the closed position.
Using the special tool, install both boot clamps.
11. If removed, use the special tools to install the dust seal.
12. Install the halfshaft assembly in the vehicle.
