Mountaineer AWD V8-4.6L VIN 8 (2006)
VACUUM CONTROL MOTOR - FLOOR DOOR
Removal and Installation
1. Remove the instrument panel. Refer to: Body and Frame, Interior Moulding/Trim, Dashboard/Instrument Panel, Service and Repair, Instrument
Panel, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel
2. Remove the shield screw.
3. Remove the shield.
4. Disconnect the floor door vacuum control motor vacuum connector.
5. Remove the 2 floor door vacuum control motor screws.
6. Rotate the floor door vacuum control motor until it clears the retaining arm and remove the vacuum control motor.
7. To install, reverse the removal procedure.
