Mountaineer RWD V6-4.0L (2008)
11. Remove the bolts and position the A/C compressor and power steering pump bracket aside.
12. Install the special tools on the front of the LH camshaft and tighten the 2 top clamp bolts to 10 Nm (89 lb-in).
13. Remove the bolt and position the camshaft sprocket aside.
Both sides
14. NOTE: Mark the position of the camshaft bearing caps so they can be installed in their original positions.
Remove the bolts in the sequence shown and remove the camshaft bearing caps.
15. Remove the camshaft.
Installation
NOTE: Lubricate the camshaft journal bearing surfaces on the cylinder head, the camshaft journals and the camshaft bearing caps with clean engine
oil.
Both sides
1. Install the camshaft.
2. NOTE: The camshaft bearing caps must be installed in their original positions.
