Mountaineer RWD V6-4.0L (2008)
Water Pump: Service and Repair
Coolant Pump - 4.0L SOHC
Removal and Installation
1. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding.
2. Remove the cooling fan.
3. Remove the accessory drive belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
4. Remove the bolts and the coolant pump pulley.
^
To install, tighten to 25 Nm (18 lb-ft).
5. Release the clamp and disconnect the coolant pump bypass hose.
6. Release the clamp and disconnect the heater hose.
7. Release the clamp and disconnect the lower radiator hose.
8. Remove the bolts, the coolant pump and the gasket.
^
To install, tighten to 10 Nm (89 lb-in).
