Mountaineer RWD V6-4.0L (2008)
Exhaust System - Exploded View 4.6L Explorer/Mountaineer (Part 2)
Removal
CAUTION: Do not use oil or grease-based lubricants on the isolators. These lubricants may cause deterioration of the rubber. This can lead
to separation of the isolator from the exhaust hanger bracket during vehicle operation. Use only water-based lubricants on the isolators.
NOTE: Exhaust fasteners are of a prevailing torque design. Use only new fasteners with the same part number as the original. Torque values must be
used as specified during reassembly to make sure of correct retention of exhaust components.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Loosen the muffler assembly-to-tailpipe Torca(R) clamp.
3. Disconnect the rubber isolator and remove the tailpipe.
Installation
1. Position the tailpipe and connect the rubber isolator.
2. NOTE: Using an abrasive pad, clean the muffler assembly-to-tailpipe surface area of any rust.
Position the muffler assembly-to-tailpipe and make sure the tab on the muffler assembly is seated inside the notch on the tailpipe and then tighten
the Torca(R) clamp.
^
Tighten to 48 Nm (35 lb-ft).
3. Check to see if the exhaust system isolators are at zero load. If the exhaust system isolators are not at zero load, then carry out the exhaust system
alignment procedure.
