Mountaineer RWD V6-4.0L (2008)
-
TIRE SENSOR FAULT
The message center displays messages that indicate a system state during the operation of the four wheel drive (4WD) system. The displayed warning
messages are as follows:
-
FOR 4X4 LOW STOP VEHICLE (if equipped)
-
FOR 4X4 LOW SHIFT TO N (if equipped)
-
TO EXIT 4X4 LOW STOP VEHICLE (if equipped)
-
TO EXIT 4X4 LOW SHIFT TO N (if equipped)
The message center displays messages that indicate a system state during repair procedures related to the tire pressure monitoring system (TPMS). The
displayed warning messages are as follows:
-
TRAIN TIRES
-
TIRES TRAINED
-
TIRES NOT TRAINED
The message center displays messages that indicate a system state during repair procedures related to the compass display. The displayed warning
messages are as follows:
-
COMPASS ZONE XX (base instrument cluster [IC])
-
RESET FOR ZONE SETTING (high series instrument cluster [IC])
-
ZONE XX RESET TO CHANGE (high series instrument cluster [IC])
-
ZONE XX IS SET
-
PRESS RESET FOR CALIBRATION (high series instrument cluster [IC])
-
CIRCLE SLOW TO CALIBRATE (base instrument cluster [IC])
-
CIRCLE SLOWLY TO CALIBRATE (high series instrument cluster [IC])
-
CALIBRATION COMPLETED
The message center displays messages that indicate a system state during repair procedures related to the oil life and oil life start value. The displayed
warning messages are as follows:
-
HOLD RESET IF NEW OIL
-
OIL LIFE SET TO 100%
-
OIL LIFE START VALUE SET TO XXX% (high series instrument cluster [IC])
-
OIL LIFE SET TO XXX% (base instrument cluster [IC])
Outside Air Temperature Sensor (Instrument Cluster [IC] Without Electronic Automatic Temperature Control [EATC])
The instrument cluster (IC) receives the outside air temperature data from the outside air temperature sensor. This data is then displayed on the
message center. The outside air temperature sensor is located on the radiator core support behind the front grill assembly and is fastened with a
pin-type retainer. If equipped with EATC, the outside air temperature data from the outside air temperature sensor is displayed in the heating
ventilation air conditioning (HVAC) module. Refer to Heating and Air Conditioning for the outside air temperature display in the EATC.
Compass
The compass heading is displayed as one of N, NE, E, SE, S, SW, W and NW in the message center display. The compass reading may be affected
when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic or metallic objects placed in, on or near the
vehicle may also affect compass accuracy. The compass sensor module is mounted behind the interior rear view mirror.
