Mountaineer RWD V6-4.0L (2008)
Oil Temperature Sensor For ECM: Service and Repair
OIL TEMPERATURE SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the engine oil.
-
Install the drain plug and tighten to 26 Nm (19 lb-ft).
3. Disconnect the oil temperature sensor electrical connector.
4. Remove the oil temperature sensor.
-
To install, tighten to 15 Nm (11 lb-ft).
5. To install, reverse the removal procedure.
-
Inspect the O-ring seal and install a new O-ring seal if necessary.
-
Fill the engine with clean engine oil.