Mountaineer RWD V6-4.0L (2008)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the crankshaft position (CKP) sensor electrical connector.
3. Remove the bolt and the CKP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
4. NOTE: Be sure the sensor wiring is routed away from the battery cable.
To install, reverse the removal procedure.
