mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

ABOUT US
Diagram Information and Instructions|Page 4108 > < Diagram Information and Instructions|Page 4106

Mountaineer RWD V6-4.0L (2008)

Page 4
background image

12. Move the rubber boot back over the TR electrical connector.

13. NOTE: If the selector lever cable shield is loose on the selector lever cable, replace the selector lever cable shield.

Install the selector lever cable shield.

14. Verify that the selector lever cable is adjusted correctly.
15. Verify that the vehicle will start in PARK and NEUTRAL and that the reverse lamps illuminate in REVERSE.

Diagram Information and Instructions|Page 4108 > < Diagram Information and Instructions|Page 4106