Mountaineer RWD V6-4.0L (2008)
PCM
Removal
All vehicles
1. NOTE: PCM installation DOES NOT require new keys.
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure.
Vehicles equipped with a 4.6L (3V) engine
2. Remove the air cleaner.
All vehicles
3. Disconnect the RH front wheel speed sensor electrical connector. Remove the nut(s) and position the A/C tube bracket(s) and wiring harness aside.
4. Disconnect the PCM connectors.
5. Remove the bolts and the PCM.
Installation
All vehicles
1. Install the PCM and bolts.
-
Tighten to 10 Nm (89 lb-in).
2. Connect the PCM electrical connectors.
3. Position the wiring harness and the A/C tube bracket(s) and install the nut(s). Connect the RH front wheel speed sensor electrical connector.
