Mountaineer RWD V6-4.0L (2008)
Seat Occupant Classification Module - Air Bag: Service and Repair
OCCUPANT CLASSIFICATION SYSTEM MODULE (OCSM)
Removal and Installation
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
Power seat shown, manual seat similar.
-
Seat is removed for clarity.
1. Depower the SRS.
2. From underneath the front of the seat, disconnect the occupant classification system module (OCSM) electrical connector.
3. NOTE: Note the position of the locator tab on the OCSM for installation.
Remove the 2 screws and the OCSM.
-
To install, tighten to 2 Nm (18 lb-in).
4. To install, reverse the removal procedure.
5. Repower the SRS. Do not prove out the SRS at this time.
4. To install, reverse the removal procedure.
5. Repower the SRS. Do not prove out the SRS at this time.
6. Carry out the appropriate procedure after installation of an OCS system component.
-
If installing the original OCS system component, carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove
