Mountaineer RWD V6-4.0L (2008)
-
Child safety seat tether bracket assemblies
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion, a new
safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its
original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and
attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
NOTE: Seat is removed and exploded for clarity.
1. Fold the seat and tilt to the E-Z entry position.
2. Remove the 3 screws and inboard recliner outer cover side shield.
3. Remove the bolt and safety belt anchor.
-
To install, tighten to 55 Nm (41 lb-ft).
4. Release the backrest trim cover retainers.
5. Remove the safety belt bezel.
6. NOTE: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest
foam pad.
Invert the backrest trim cover.
7. CAUTION: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the backrest foam pad.
Release the hook-and-loop strips.
8. Remove the pin-type retainer and safety belt retractor cover and insulator.
9. Remove the bolt and safety belt retractor.
-
To install, tighten to 75 Nm (55 lb-ft).
10. To install, reverse the removal procedure.
11. Check the active restraint system for correct operation.
