Mountaineer RWD V6-4.0L (2008)
Brake Switch (Cruise Control): Service and Repair
SPEED CONTROL DEACTIVATOR SWITCH
Removal
CAUTION: Do not remove or repair the brake pedal, brake booster or master cylinder without first removing the speed control deactivator
switch. Do not install the speed control deactivator switch without the brake pedal arm secured to the brake booster push rod. Do not pull or
push on the brake pedal when removing or installing the speed control deactivator switch, as misadjustment or damage to the switch may
occur.
1. Disconnect the speed control deactivator switch electrical connector.
2. Rotate counterclockwise 45 degrees and remove the speed control deactivator switch.
Installation
NOTE: When installing the speed control deactivator switch it is automatically self-adjusting to the proper position. Do not pull up or push down on
the pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are
necessary, install a new switch.
1. Install the speed control deactivator switch, and rotate clockwise 45 degrees.
2. Connect the speed control deactivator switch electrical connector.
