Mountaineer RWD V6-4.0L (2008)
3. NOTE: Both fuel gauge sending wires must be routed behind the metal sending unit plate.
Hook the fuel level sender on the fuel pump and install and tighten the screw. Connect the fuel level sender unit ground wire.
4. Slide the heat shrink tube onto the wire harness and connect the fuel level sender wire electrical connector.
5. WARNING: Do not use an open flame to shrink the heat shrink tube. Use a heat gun only. Fuel residue may be ignited if an open flame is
used. Failure to follow this instruction may result in serious personal injury.
Using a heat gun, shrink the heat shrink tube.
6. Install the fuel level sender cover and screw and tighten the screw.
7. Install the fuel pump.
