Mountaineer RWD V6-4.0L (2008)
11. Connect the special tools.
^
Connect the open end of the fluid hose from the Fluid Transporter/Evacuator/Injector to the Fluid Level and Fill Plug Adapter at the bottom of
the transmission fluid pan.
12. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the special tool. Transmission fluid will immediately
start flowing out of the special tool into the transmission fluid pan.
13. Add 0.5L (1 pt) of transmission fluid into the transmission fluid pan. Stop the process by releasing the air pressure and removing the air nozzle
from the end of the hose.
14. Inspect the transmission fluid level in the special tool. If the transmission fluid drains back into the canister, the transmission is full. If no
transmission fluid drains back, more transmission fluid will need to be added. Repeat Steps 12 and 13.
15. Once the transmission is full, place a hand vacuum pump on the open end of the vacuum/pressure hose on the special tool and apply vacuum to the
system. This will pull out any extra transmission fluid trapped in the system and direct it into the container.
16. Allow the transmission fluid to drain. Make sure that the fluid temperature is between 27-49° C (80-120° F). When the transmission fluid comes
out as a thin stream or drip, the transmission fluid is at the correct level.
