Mountaineer RWD V6-4.0L (2008)
1. With the vehicle in PARK, position it on a hoist.
2. Use a suitable flush and fill machine to change the fluid.
3. When connecting the flush and fill machine, connect the machine to the transmission fluid cooler tube after the transmission fluid cooler on the
transmission fluid cooler return tube. This will help remove any foreign material trapped in the transmission fluid coolers.
Refill
1. Use only clean transmission fluid.
2. Once the transmission fluid exchange has been completed, disconnect the flush and fill machine. Reconnect any disconnected fluid cooler tubes.
3. With the engine running, check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission
fluid in increments of 0.24L (0.5 pt) until the correct level is achieved. For additional information, refer to Transmission Fluid Level Check. See:
Service and Repair/Procedures/Transmission Fluid Level Check
Transmission Fluid Drain and Refill -Without Torque Converter Drain Plug
Transmission Fluid Drain and Refill -Without Torque Converter Drain Plug
