Mountaineer RWD V6-4.0L (2008)
Shift Cable: Adjustments
Selector Lever Cable Adjustment - 6R60
Selector Lever Cable Adjustment - 6R60
1. With the vehicle in NEUTRAL, position the vehicle on a hoist.
2. Place the selector lever in the PARK position.
3. Move the selector lever 3 detents. This should be the (D) position.
4. Remove the selector lever cable shield by prying on the side of the selector lever cable shield closest to the boot, then sliding the shield away from
the boot.
5. Disconnect the selector lever cable from the manual control lever.
6. Rotate the manual control lever clockwise until the travel stops. Then rotate the manual control lever counterclockwise 3 detents. This should be
the (D) position.
7. With the selector lever cable end disconnected, unlock the tab on the selector lever cable end by sliding it up.
