Mountaineer RWD V6-4.0L (2008)
Removal and Installation
1. CAUTION: Do not loosen the rear axle wheel end nut until after the wheel and tire assembly are removed from the vehicle. Wheel
bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the rear wheel and tire.
3. Remove and discard the rear axle wheel end nut.
^
To install, tighten to 275 Nm (203 lb-ft).
4. CAUTION: Do not use a hammer to separate the rear axle halfshaft assembly from the hub. Damage to the threads and internal constant
velocity (CV) joint components may result.
Using the special tool, press the outboard constant velocity (CV) joint until it is loose in the hub.
5. Remove the brake cable retainer screw.
^
To install, tighten to 20 Nm (15 lb-ft).
