Mystique L4-122 2.0L DOHC VIN 3 SFI (1995)
Follow the provisions of the Warranty and Policy Manual.
EXCESS STOCK RETURN
Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.
Attachment III - Technical Information
HEATER BLOWER SWITCH AND CONNECTOR REPLACEMENT
OVERVIEW
When performing this service procedure, you will:
^
replace the existing blower switch wire harness connector with a redesigned connector
^
replace the existing blower switch
^
verify the repair
SERVICE PROCEDURE
CAUTION:
Do not use excessive force when installing the Radio Removing Tool. This may damage the retaining clips, making radio chassis removal difficult.
1.
Remove the radio.
^
Record the radio stations.
^
Install the Radio Removing Tool T87 P-19061-A into the radio face plate.
^
Push the tool in approximately 25.4 mm (1 inch) to release the retaining clips.
^
Apply a slight spreading force on the tool and pull the radio out.
^
Disconnect the radio connectors.
2.
Remove the A/C control finish panel. See Figure 1.
