Mystique L4-122 2.0L DOHC VIN 3 SFI (1995)
^
Connect accelerator cable to throttle body lever and cable bracket.
^
Fully depress and hold the accelerator pedal again (this will set the second adjuster).
^
Fine tune second adjuster: Pull accelerator cable housing out of adjuster until wide open throttle (WOT) at throttle body is achieved then
install clip to lock the adjuster. See Figure 11. Observe position of throttle body air valve to ensure WOT is achieved.
^
Remove 1.3 mm (0.05 inch) wire from traction control motor pulleys.
^
Make sure the throttle body air valve moves to WOT position when the accelerator pedal is fully depressed. (If throttle body does not move to
WOT position, the adjuster may be moved one notch to achieve WOT.)
^
With the accelerator in idle position, check the position of throttle body air valve. Air valve should be closed and accelerator cable should
deflect 1-3 mm (0.04-0.12 inch) midway between accelerator cable bracket and throttle body fever.
20.
Install traction control motor electrical connector and cover.
21.
Install air intake resonators. Tighten bolt/nut to 3-5 Nm (27-44 lb/in).
Accelerator Cable Replacement - 2.5L Engine
1.
Open hood.
2.
Remove coolant recovery reservoir retaining bolts, then slightly raise reservoir.
3.
Disconnect low coolant sensor electrical connector and accelerator cable from bottom of coolant recovery reservoir.
4.
Position coolant recovery reservoir aside.
