Mystique L4-122 20L DOHC VIN 3 SFI - Air Bag Arming and Disarming - Service and Repair
Air Bag(s) Arming and Disarming: Service and Repair
Arming and Disarming
DEACTIVATION PROCEDURE
1. Disconnect battery ground cable.
2. Disconnect positive battery cable.
3. Wait one minute. This is the time required for back-up power supply in air bag diagnostic monitor to deplete its stored energy.
4. Remove driver side air bag module.
WARNING: Place air bag module on bench with trim cover facing up to avoid accidental deployment and possible personal injury.
5. Disconnect driver air bag connector. Remove driver side air bag module from vehicle.
6. Attach one Rotunda Air Bag Simulator 105-00010 or equivalent to air bag sliding contact connector at top of steering column.
7. Remove the passenger side air bag module. After disconnecting the air bag connector, connect a second Rotunda Air Bag Simulator 105-00010 to
the wiring harness in place of passenger side air bag module.
8. Reconnect positive battery cable.
9. Reconnect battery ground cable.
REACTIVATION PROCEDURE
1. Disconnect battery ground cable.
2. Disconnect positive battery cable.
3. Wait one minute for back-up power supply in air bag diagnostic monitor to deplete its stored energy.
4. Remove Rotunda Air Bag Simulator 105-00010 or equivalent from air bag sliding contact connector if connected.
WARNING: To avoid personal injury the air bag simulator(s) must be removed and the air bag(s) reconnected when the system is
reactivated.
5, Re-connect and re-install driver side air bag module.
6. Remove Rotunda Air Bag Simulator 105-00010 or equivalent from the wiring harness, reconnect passenger side air bag module and install.
7. Reconnect positive battery cable.
8. Reconnect battery ground cable.
9. Prove out system.
