mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

M/T - Clash/Grind Shifting into Third Gear|Page 6277 > < M/T - Clash/Grind Shifting into Third Gear|Page 6275
Page 7
background image

b.

Using Bearing Pulling Attachment D84L-1123-A, or equivalent, press off the 5th gear wheel with the input shaft bearing (Figure 11).

^

1)

Slide the snap ring up out of the annular groove until it sits below the input shaft bearing

^

2)

Press off 5th gear together with the snap ring and input shaft bearing (Figure 12)

M/T - Clash/Grind Shifting into Third Gear|Page 6277 > < M/T - Clash/Grind Shifting into Third Gear|Page 6275