mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Rear Door Latch|Service and Repair|Page 7913 > < Rear Door Exterior Handle|Service and Repair|Page 7909
Page 1
background image

Rear Door Latch: Service and Repair

REMOVAL

1. Disconnect the battery negative lead.
2. Remove the door trim panel.
3. Remove the door pull.

4. Peel back the door watershield.

-

Using a plastic knife (disposable cutlery), cut through the Butyl strip to enable the watershield to be peeled back.

CAUTION:  Do not touch the adhesive surface as re-bonding will be impaired. Do not attempt to peel the weather shield from the door without
cutting the Butyl strip.

5. Disconnect the door latch remote control illumination lamp electrical connectors.

6. Remove the latch remote control.

1. Remove the screws.
2. Pry the handle housing out.

Rear Door Latch|Service and Repair|Page 7913 > < Rear Door Exterior Handle|Service and Repair|Page 7909