mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Axle Shaft|Removal and Installation|Page 5104 > < Axle Shaft|Removal and Installation|Page 5102
Page 15
background image

Install the halfshaft.

3. CAUTION: Do not damage the CV joint boot and the wheel speed sensor ring. 

Attach the lower suspension arm to the wheel knuckle.
^

Attach the wiring harness bracket to the suspension strut.

4. Install the splash shields.
5. Install the front wheel.
Vehicles with manual transaxle

6. NOTE:  The fill level is 0-5 mm below the lower edge of the filler hole.

Check the transmission fluid level and fill up with Transmission fluid - manual transaxle if necessary.

Axle Shaft|Removal and Installation|Page 5104 > < Axle Shaft|Removal and Installation|Page 5102