Mystique V6-153 2.5L DOHC VIN L SFI (1999)
Flywheel: Testing and Inspection
Surface
1. Use a fine grade sandpaper (40 grit) for polishing or as necessary machine the flywheel surface to remove any defects.
2. After resurfacing, the flywheel must be within specification.
1
The surface runout must not exceed specification.
2
The surface finish must be within specification.
3
The major diameter of any dowel pin must be below the new flywheel surface.
4
The clutch pressure plate bolts must screw into the flywheel by hand to within specification of the new flywheel surface.