Sable V6-182 3.0L (1986)
surface, are normal and not detrimental. Honing of the bore on aluminum master cylinders is not permitted as the anodic coating and hardness
could be removed.
ASSEMBLY
1. Dip replacement piston assemblies in clean DOT 3 brake fluid for lubrication prior to assembly into cylinder.
2. Install secondary (smaller) piston assembly into bore, spring end first.
3. Install primary piston assembly, spring end first.
4. Depress primary piston and install snap ring.
5. Install the fluid control valve, tighten to 11-13 Nm (97-115 in lb).
6. Wet new grommets in clean brake fluid and press into brake master cylinder.
7. Wet reservoir ports with clean brake fluid and press new reservoir assembly into grommets.
8. Fill master cylinder and perform brake bleeding procedure.
9. Install cap on master cylinder reservoir and secure.
