mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Dimmer Switch > < Dashboard / Instrument Panel|Service and Repair|Page 10493
Page 3
background image

vacuum hose, heater-A/C control cables and radio antenna.

11. Disconnect all underhood electrical connectors of main wire loom. Disengage rubber grommet from dash panel and feed wire and connector into

instrument panel area.

12. Remove one instrument panel brace retaining screw located under radio.
13. Remove two lower instrument panel to cowl retaining screws, Fig. 52.
14. Remove right and left side speaker covers, then defroster grille, Fig. 53.
15. Remove three upper instrument panel retaining screws.
16. Remove instrument panel from vehicle.
17. Reverse procedure to install.

Dimmer Switch > < Dashboard / Instrument Panel|Service and Repair|Page 10493