Sable V6-182 3.0L (1986)
Figure 1
6.
Using metal shears (tinsnips), cut through the retainer as shown on Figure 1. Bend one cut side of the metal up and the other cut side down enough
to allow the wiring assembly to slip through metal opening and remove the moulding assembly from the door.
7.
Cut and bend the new moulding assembly in the same way and slide it into place on the door.
8.
Install the screw that retains the front part of the moulding tight against the door outer panel.
9.
Position the mirror and install the three retaining nuts. Tighten to approximately the same torque as was required for removal (specification is
2.8-4.5 N-m).
10.
Install the watershield tape and the inside mounting hole cover screw.
