Sable V6-182 3.0L (1986)
7.
Install new Nylon Flat Washer (Item 1) and apply the Anti-Seize Compound (Item 10) completely to the Hub Pin.
8.
Install the Stainless Steel Sleeve (Item 2) over the Throttle Body Hub Pin.
9.
Install the new Secondary Throttle Lever Assembly (Item 3) over the Stainless Steel Sleeve with the hub toward the throttle body casting.
10.
Install new External Retaining Ring (Item 8) on Hub Pin.
11.
Remove existing bushing (Item 4) on Primary Throttle Control Lever.
12.
Install new Throttle Control Lever Bushing (Item 4).
13.
Install new Throttle Control Rod (Item 7) with new Rod Attaching Washers (Item 5) and Lever Attaching Rings (Item 6).
14.
Install new Throttle Return Spring (Item 9) and reconnect accelerator cable.
15.
Wipe off excess compound.
16.
Verify free linkage movement and return to idle position.
17.
Reinstall snow shield.
18.
Start engine and verify proper linkage operation.
19.
Ensure all replaced parts are mutilated and scrapped.
Attachment IIIB - Repair Procedure
Throttle Body Hub Pin Cleaning, Lubrication And
Throttle Lever Service Kit Installation
Affected Vehicles:
1986-1988 Ranger/Bronco II 2.9L
See Attachment IIIA for the Repair Procedure on the 1986-1989 3.0L Taurus/Sable
Repair Procedure For 1986-1988 2.9L Ranger/Bronco II Throttle Lever Kit
(Refer to illustration for item references.)
2.9L Ranger/Bronco II Throttle Lever Kit
THROTTLE LEVER
KIT CONTENTS
ITEM NUMBER
PART DESCRIPTION
QUANTITY
1
FLAT WASHER
1