Sable V6-183 3.0L DOHC VIN S MFI (1997)
4. Disconnect connector for driver side air bag module from connector for air bag sliding contact.
5. Remove driver side air bag module from steering wheel.
WARNING: PLACE AIR BAG MODULE ON BENCH WITH TRIM COVER FACING UP TO PREVENT AIR BAG FROM
BECOMING AIRBORNE IN EVENT OF ACCIDENTAL DEPLOYMENT.
6. Disconnect connectors for LH and RH speed control actuator switches by depressing locking tang and pulling switch printed circuit and connector
end out of electrical socket in steering wheel.
7. Remove two Torx(R) -head screws retaining each speed control actuator switch to steering wheel.
8. Remove speed control actuator switches from steering wheel.
INSTALLATION
1. Position two new speed control actuator switches onto steering wheel and install four Torx(R) -head screws.
2. Connect two speed control actuator switch harness connectors.
3. Position driver side air bag module and connect air bag sliding contact.
4. Install driver side air bag module on steering wheel and install two screws. Tighten to 10-14 N.m (89-124 Lb-In).
5. Install two steering wheel spoke covers.
6. Re-connect positive battery cable.
7. Re-connect battery ground cable.
8. Check operation of speed control actuator switches.
9. Prove out air bag system.
