Sable V6-183 3.0L VIN U FI (1998)
CAUTION: Parking brake lever pin retainer clip should click into place. To prevent damage, do not overcompress right hand anti-rattle spring.
9. Install new piston seal in groove in caliper housing after lubricating seal with High Performance DOT-3 Motor Vehicle Brake Fluid
C6AZ-19542-AB or DOT-3 equivalent meeting Ford specification ESA-M6C25-A.
10. Coat rear disc brake piston and adjuster and piston dust boot with High Performance DOT-3 Motor Vehicle Brake Fluid C6AZ-19542-AB or
DOT-3 equivalent meeting Ford specification ESA-M6C25-A. Install dust boot into piston bore of rear disc brake caliper. Spread dust boot over
rear disc brake piston and adjuster and seat dust boot in piston groove. Rotate rear disc brake piston and adjuster clockwise using Rear Caliper
Piston Adjuster 206-026 until piston is fully seated.
NOTE: Make sure one slot in rear disc brake piston and adjuster face is positioned so it will engage with nib on brake shoe.
11. Install rear disc brace caliper assembly.
Removal and Installation
REMOVAL
1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
3. Remove retaining bolt and rear wheel brake hose from rear disc brake caliper assembly and plug.
