Sable V6-183 3.0L VIN U FI (1998)
INSTALLATION
1. Locate parking brake control onto the three cowl side studs.
2. Fit front parking brake cable and conduit through its mounting hole seat grommet on front parking brake cable and conduit, press pronged retainer
in place. Make sure prongs are securely locked in place. Connect the parking brake control end fitting to clevis at parking brake control.
3. Install retaining nuts to cowl side bracket. Tighten nuts to 26 - 34 Nm (19 - 25 ft. lbs.).
4. Reposition and install fuse panel / junction box.
5. Connect release cable to parking brake control release arm and install release cable grommet to parking brake control.
6. Connect wiring connector to parking brake signal switch and bracket.
7. Raise vehicle. Check parking brake operation and adjust as required. Lower vehicle.
