Sable V6-183 3.0L VIN U FI (1998)
12. Install engine control sensor wiring to each fuel injector. Secure wire harness retainers to valve cover stud bolts.
13. Install ignition coil to rear of LH cylinder head. Tighten retaining bolts to 40-55 Nm (30-40 ft. lbs.).
14. Install ignition wire harness retainers to valve cover stud bolts and connect ignition wires to spark plugs and ignition coil.
15. Install upper intake manifold.
16. Install EGR valve to exhaust manifold tube from intake manifold to EGR valve (EGR valve).
17. Install fuel tubes.
18. Install fuel tube safety retaining clips.
19. Install upper radiator hose and heater water hoses. Tighten retaining clamps securely.
20. Connect vacuum lines to premarked locations.
21. Connect electrical connections to idle air control valve engine coolant temperature sensor throttle position sensor, EGR backpressure transducer,
EGR vacuum regulator solenoid, ignition coil and water temperature indicator sender unit.
22. Fill and bleed engine cooling system.
NOTE: Engine coolant is corrosive to all engine bearing material. Replacing oil after removal of a coolant carrying component prevents damage.
23. Fill crankcase to the proper level with clean engine oil XO-5W30-QSP meeting Ford specification WSS-M2C153-G.
24. Install air cleaner outlet tube to throttle body and engine air cleaner.
25. Install crankcase ventilation tube to valve cover and air cleaner outlet tube. Install aspirator hose to air cleaner outlet tube.
26. Connect battery ground cable.
27. Start engine and check for coolant, oil, fuel and vacuum leaks.
