Sable V6-183 3.0L VIN U FI (1998)
Accumulator HVAC: Description and Operation
NOTE: Replacement of the suction accumulator/drier is necessary any time a major component of the refrigerant system is replaced. Major components
include the following:
-
A/C condenser core
-
A/C compressor
-
A/C evaporator core
-
a refrigerant hose/line
An A/C evaporator core orifice or O-ring seal is not considered a major component but the A/C evaporator core orifice should be replaced whenever the
A/C compressor is replaced for lack of performance.
The suction accumulator/drier is mounted on the A/C accumulator bracket and positioned to the right of the radiator. The inlet tube of the suction
accumulator/drier is attached to the A/C evaporator core. The outlet tube attaches to the A/C manifold and tube.
After entering the inlet of the suction accumulator/drier, heavier oil-laden refrigerant contacts an internally mounted dome (which serves as an umbrella)
and drips down onto the bottom of the canister.
-
A small diameter oil bleed hole in the bottom of the vapor return tube allows the accumulated heavier liquid refrigerant and oil mixture to re-enter
the compressor suction line at a controlled rate.
-
As this heavier mixture passes through the small diameter liquid bleed hole, it has a second chance to vaporize and recirculate through the A/C
compressor without causing compressor damage due to slugging.
-
A fine-mesh screened filter fits tightly around the bottom of the vapor return tube to filter out refrigerant system contaminant particles.
-
A desiccant bag is mounted inside the canister to absorb any moisture which may be in the refrigerant system.
