Sable V6-183 3.0L VIN U FI (1998)
Throttle Position Sensor: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect engine control sensor wiring from Throttle Position sensor (TP sensor).
3. Remove two throttle position sensor retaining screws.
4. Remove throttle position sensor.
INSTALLATION
1. NOTE: This throttle position sensor is not adjustable.
CAUTION:m Slide rotary tangs into position over throttle shaft blade, then rotate throttle position sensor clockwise to installed position only.
Failure to install the throttle position sensor in this manner may result in damage to throttle position sensor or excessive idle speeds.
Install throttle position sensor. Make sure rotary tangs on sensor are in proper alignment.
2. Secure throttle position sensor to throttle body with two retaining screws. Tighten to 2.8-3.8 Nm (25-34 lb-in).
3. Connect engine control sensor wiring to throttle position sensor.
4. Connect battery ground cable.
