Sable V6-183 3.0L VIN U FI (1998)
Camshaft Position Sensor/Synchronizer: Service and Repair
SPECIAL SERVICE TOOL(S) REQUIRED
Description
-
Syncro Positioning Tool
Tool Number
-
303-589
CAUTION: Prior to removal of the Camshaft Position sensor (CMP sensor), set cylinder No.1 to zero degrees Top Dead Center (TDC) of
compression stroke. Note the position of the camshaft position sensor electrical connector. The installation procedure requires that the connector be
located in the same position.
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect engine control sensor wiring connector from camshaft position sensor.
3. Remove camshaft position sensor retaining screws and camshaft position sensor from camshaft position sensor housing.
4. If removing camshaft position sensor housing from the cylinder block, proceed with Removal Step 5. If not removing camshaft position sensor