Sable V6-183 3.0L VIN U FI (1998)
4. The individual valves and springs are removed by removing retaining clips and bore plugs. Refer to the illustrations for valve and spring locations.
Clean valves, springs and main control valve body.
Inspect main regulator boost valve and sleeve for wear. Replace valve and sleeve if worn.
CAUTION: Most valves are aluminum and cannot be removed using a magnet. Remove valves by tapping valve body on palm of hand to slide
valves out of bores. It may be necessary to remove valves and springs using a pick. If it is necessary to use a pick, use extreme caution to prevent
damaging valves or valve bores.
Assembly
1. Assemble valves and springs into main control valve body.
Valve Body Check Balls, Relief Valves, And Filter
2. Install check balls, relief valves and filters.
3. Replace valve body separator plate with bonded gasket on main control valve body.
