Sable V6-232 3.8L (1988)
Power Steering Pump: Service and Repair
Removal and Installation
V6 ENGINE
1.
Disconnect battery ground cable.
2.
Loosen idler pulley, then remove power steering belt.
3.
Using hub puller T69L-10300-B or equivalent, remove pulley from shaft.
4.
Position suitable drain pan under pump, then disconnect return line and allow fluid to drain.
5.
Completely back off pressure line fitting. Line will separate during pump removal.
6.
Remove three pump-to-bracket attaching bolts, then the pump.
7.
Reverse procedure to install.
