Sable V6-232 3.8L (1988)
Knuckle On Press (DOWN)
2. Place Front Bearing Spacer T86P-1104-A2 or equivalent step side down on hydraulic press plate and position knuckle (outboard side down) on
spacer. Position a new bearing in inboard side of knuckle. Install Bearing Installer T86P-1104-A3 or equivalent (undercut side facing bearing), on
bearing outer race and press bearing into knuckle. Ensure that bearing seats completely against shoulder of knuckle bore.
CAUTION: Bearing Installer T86P-1104-A3 or equivalent must be positioned as indicated above to prevent bearing damage during
installation.
3. Install a new snap ring (part of bearing kit) in knuckle groove using snap ring pliers.
Knuckle And Hub
4. Place Front Bearing Spacer T86P-1104-A2 or equivalent on the arbor press plate and position hub on tool with lugs facing downward. Position
knuckle assembly (outboard side down) on the hub barrel. Place Bearing Remover T83P-1104-AH2 or equivalent flat side down, centered on
inner race of the bearing and press down on tool until bearing is fully seated onto hub. Ensure that hub rotates freely in knuckle after installation.
