Sable V6-3.0L DOHC VIN S (2002)
6. CAUTION: The parking brake lever pin retainer clip and spring cover are spring-loaded. Use care when removing the parking brake lever pin
retainer clip.
Remove the parking brake lever pin retainer clip.
^
Unload the spring tension from the parking brake lever pin retainer clip and spring cover using the special tool, a 6-mm washer head nut and a
1/2-inch drive 14-mm socket.
^
Remove the parking brake lever pin retainer clip with suitable snap-ring pliers.
^
Remove the special tool, nut and socket.
7. Remove the following components:
1
Spring cover
2
Spring
3
Washer
4
Key plate
5
Push rod
6
Strut pin
7
Push rod 0-ring
8. Remove and discard the 0-ring seal from the push rod.
9. Remove the parking brake lever.
1
Remove the parking brake return spring.
2
Remove the limiting bolt.
3
Remove the parking brake lever.
4
Remove the parking brake lever shaft seat from the caliper bore.
10. CAUTION: Do not reuse piston seals or dust boots. Install new seals or dust boots or damage to the vehicle can occur.
NOTE: Use new brake fluid when assembling the disc brake caliper.
