Sable V6-3.0L DOHC VIN S (2002)
10.
Using vinyl electrical tape, secure the butt splices and the harness wires together in two or three locations. See Figure 5.
11.
Install the new stop lamp switch as follows (See Figure 6):
a)
Install the new plastic grommet onto the master cylinder pushrod.
b)
Place one new plastic washer in the brake pedal arm post, then connect the pushrod to the post.
c)
Position the new stop lamp switch onto the post, then install the other new plastic washer.
d)
Install the retainer clip.
