Sable V6-3.0L DOHC VIN S (2002)
DEALER PRICE
For latest prices, check DOES II or updated price book.
PARTS RETENTION
Follow the provisions of the Warranty and Policy Manual for "Parts Retention and Return Procedures."
EXCESS STOCK RETURN
Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.
Attachment III - Technical Information
SERVICE PROCEDURE
NOTE:
If a 2002 Focus equipped with a 2.0L Zetec engine and a dash-mounted EGR pressure sensor is encountered, call the Special Service Support
Center.
1.
Retrieve continuous DTCs.
NOTE:
Replace the EGR pressure sensor only if one or more of the following continuous DTCs are present:
^
P1400 - DPF EGR SENSOR CIRCUIT LOW VOLTAGE DETECTED
^
P1401 - DPF EGR SENSOR CIRCUIT HIGH VOLTAGE DETECTED
^
P0401- EGR FLOW INSUFFICIENT DETECTED
^
P0402- EGR FLOW EXCESSIVE DETECTED
Any other DTC present is not covered by this program.
2.
If one or more of the DTCs listed above is present, replace the EGR pressure sensor (9J460) as follows:
a)
Key off.
b)
Disconnect the electrical connector and remove the EGR pressure sensor from the EGR tube.
c)
Install the new EGR pressure sensor onto the EGR tube and connect the electrical connector. Note: Refer to Section 303-08 of the
appropriate workshop manual if additional information is required.
3.
Clear continuous DTCs.
4.
Perform KOEO and KOER self tests.
