Sable V6-3.0L DOHC VIN S (2002)
Air Bag Control Module: Service and Repair
Restraints Control Module (Rcm)
Restraints Control Module (RCM)
Removal
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
WARNING: The restraints control module (RCM) orientation is critical for correct air bag supplemental restraint system (SRS) operation. If a
vehicle equipped with an SRS system has been involved in a collision in which the center tunnel area has been damaged, inspect the mounting and
bracket for deformation. If damaged, a new RCM must be installed whether or not the air bags have deployed. In addition, make sure the area of the
RCM mounting is restored to its original condition.
WARNING: Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Install and correctly position a new sensor and
any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could
result in injury and possible violation of vehicle safety standards.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not
indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: When installing a new restraints control module (RCM), always make sure the correct RCM is being installed. If an incorrect RCM is
installed, erroneous DTCs will result.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the
diagnostic procedure again.
1. Depower the system. For additional information, See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair
2. Remove the right hand side restraints control module (RCM) retaining bolts.
1. Position the carpet back at the right hand side of the center tunnel area under the instrument panel (I/P).
2. Remove the bolts.
3. Position the carpet back at the left hand side of the center tunnel area under the instrument panel (I/P).
4. Disconnect the large RCM electrical connector.
1. Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
2. Pull out and disconnect the RCM electrical connector.
