Sable V6-3.0L DOHC VIN S (2002)
Apply urethane adhesive on top of the existing trimmed urethane adhesive bead on the pinch weld. Make sure that all gaps in the urethane
adhesive are smoothed into one continuous bead.
10.
Install the windshield glass on the vehicle aligning it with the markings made previously.
11.
Installation may be checked for leaks using Rotunda Ultrasonic Leak Detector 134-R0135 along with Signal Transmitter 134-R0136 or
equivalents. Do NOT use water to test freshly applied urethane.
12.
Position the headliner.
13.
If equipped, install the dome lamp assembly. For additional information, refer to Section 417-02.
14.
Install the two sun visor clips, the LH and RH sun visors, and the eight screws.
15.
NOTE: When installing the windshield side garnish mouldings, be sure the alignment tabs are positioned correctly.
Install the RH and LH windshield garnish mouldings.
16.
Install the RH and LH front door weatherstrips.
17.
Install the interior rear view mirror. For additional information, refer to Section 501-09.
18.
Install the cowl grill. For additional information, refer to Section 501-02.
