Sable V6-3.0L VIN 2 Flex Fuel (2005)
13. NOTE: When assembled, a small gap between one of the gears and the drive tube may exist.
Assemble the seat track motor assembly, upper support assembly and inboard track together.
1
Align the drive tube to the motor stub shaft. Tap the nose of the inboard track gear toward the seat track motor stub shaft.
-
Positioning a block of metal or wood behind the motor gear can aid assembly.
2
While tapping the parts together, simultaneously engage the front and rear lift links to the inboard track.
-
When the lift links are up against the inboard track, with the bushings through the hole and seated, the drive tube is fully engaged.
14. Install the nuts holding the inboard track to the upper support assembly lift links.
15. Check to make sure the index marks on the inboard track C-channel and plastic coated slide are still in alignment.
-
The index marks on the inboard track C-channel and plastic coated slide must align at this step. If the index marks do not match up, repeat
Steps 12 through 14.
