Sable V6-3.0L VIN 2 Flex Fuel (2005)
6. Tighten the bleeder screw.
Vehicles with rear disc brakes
7. Tighten the bleeder screw.
All vehicles
8. Repeat Steps 2-7 for the LH rear bleeder screw, the RH front bleeder screw and the LH front bleeder screw, in that order.
9. Connect the diagnostic tool adapter cable into the vehicle Data Link Connector (DLC) under the dash, and follow the diagnostic tool instructions
for bleeding.
10. Repeat the conventional bleed procedure as described in Steps 2-7.
Caliper
Caliper
WARNING: Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the
brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake
fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
CAUTION: Do not allow the master cylinder to run dry during the bleeding operation. Keep the master cylinder reservoir filled with the specified
brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
1. NOTE: It is not necessary to do a complete brake system bleed if only the disc brake caliper was disconnected.
