Sable V6-3.0L VIN 2 Flex Fuel (2005)
10. Remove the three nuts at the dash panel.
11. Remove the screws and the heater outlet floor duct.
12. Remove the bolt and nut.
13. Remove the heater core and evaporator core housing.
INSTALLATION
1. To install, reverse the removal procedure.
-
Lubricate the coolant hoses with plain water only, if needed.
-
Install new refrigerant system O-ring seals lubricated in clean mineral oil.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
2. Evacuate, leak test and charge the A/C system.
3. Refill the cooling system.
