Sable V6-3.0L VIN 2 Flex Fuel (2005)
1.
Disconnect the existing "christmas tree" retainer from the "pencil" brace (Figure 2).
2.
Remove the existing pencil brace bolt from the cylinder head and the nut from the intake. Retain the nut for reuse and discard the pencil brace
(Figure 2).
3.
Slide the IAC wiring harness holder off the lower right throttle body bolt (Figure 2).
4.
Remove the lower left throttle body bolt and discard (Figure 3).
5.
Install the new throttle body stud in the lower left corner of the throttle body and torque to 40-60 lb-in (4.5-7 N.m) (Figure 3).
6.
Install the new "chnstmas tree" retainer on the wiring harness, 3/4" (20 mm) towards the front of the vehicle and 180 degrees opposite the existing
retainer. Use black electrical tape or equivalent to install, by applying to each side of connector (3 complete wraps around the harness) (Figure 4).
7.
Install the new support bracket on both lower throffle body studs and fasten with bolt in cylinder head. Harness must be on the inboard side of
bracket (Figure 3).
