Sable V6-3.0L VIN 2 Flex Fuel (2005)
8. Set the halfshaft assembled length to specification.
1. Measure the assembly length as shown.
2. Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length to specification.
3. Hold the inner joint to prevent the assembled length from changing, and insert a small flat blade screwdriver between the boot and the joint to
equalize the pressure.
9. NOTE: Make sure the front wheel driveshaft joint boot seats in the groove.
Install the clamps as tight as possible by hand.
10. Using the special tool, tighten the clamp.
^
Position the special tool on the clamp ear, and tighten the tool through bolt until the tool closes completely.
